Imako Cosmetic Upper Teeth (Large, Natural)

Description: Imako Cosmetic Upper Teeth (Large, Natural) Features UPPERS ONLY in Natural Coloring, Size Large. Fitting Material Included. Freedom to smile, drink and smoke while wearing. Safest Cosmetic Tooth cover, no Dental Visit Necessary! Made in USA and FDA Approved. Do your own Smile Makeover, Fit in Your Own Kitchen! Fits securely, comfortably over your upper teeth. No lisping. Hides tooth loss/crookedness/stains/broken teeth and can be fitted over crowns, veneers, partials and bondings. Fitting: Measure across the width of the four front teeth. If it is closer to 1-1/8th inches (28 mm.) order size small. If closer to 1-1/4th inches (32 mm.) order size large. Description Imako Cosmetic Upper TeethBefore you Begin: Wash handsFloss & brush teethReview the instruction bookletItems Needed:MirrorTimer with secondsPot of simmering waterCeramic bowlScissors/nail clippers Imako Teeth Arrive Flat. After Fitting they are arch-shaped, springy and have your tooth imprints on the inner layer. They will snap right on! FittingSoften a chunk of pink plastic in a bowl of very hot water. Remove with a spoon. Roll it out on your palm until you have a thin tube size of a spaghetti noodle the width of your palm (you will be given more than neccesary). Keep soft by dipping in hot water.Turn the Imako Teeth updside down and briefly into the water to make it receptive to bonding. Attach the pink spaghetti piece to the top edge of the back layerRefresh the hot water in bowl. Place teeth face down in the bowl. When the back layers turns completely clear, pour off the water.The teeth will be floppy. Use a mirror to pull your lips forward, insert and position teeth. Press firmly against each of your teeth. Gently rub through your lip to get the pink to lay against your gums. Keep it still.Use one hand to keep sides in place and one hand to keep front in place. Gently support the position for two minutes.Remove teeth by spreading from below. Let cool until back layer turns white. Try them on! If not satisfied, you can melt it back and try again. For Missing TeethOptional for missing teeth: The white beads are used to make projections on the inside surface which snap between your teeth. These projections work like the male side of a snap fastener, and reinforce the strength where your teeth are missing. Melt two beads per missing tooth. Dip the area where you have no tooth imprint very, very briefly in hot water. Place the beads there. Position in mouth and from behind, press the warm plastic to butt up to neighboring teeth, but not behind them. Let cool until material is slightly soft to remove. It's easy to add more but hard to take away so be conservative. For teeth missing on one side, use melted beads to halfway wrap around the last tooth. To wear, put this side on first and take off last. When only front teeth exist, bond 2 or 3 beads along the bottom edge where you have teeth and fold the material around the back. Press is out to be very thing so it is flexivle. Bite down and slide. Reinfoce sides with extra melted beads. Shipping PolicyFree Shipping within the 48 states. Alaska, Hawaii, and Puerto Rico have to pay extra S&H feeShipment can take up to 10 days (Small packages ONLY), and some items may not be permitted to ship to these locations. If any shipment is not permitted to your area, full refund will be issued within two business days. Thank you for your understanding. Return Policy accepted within 14 days after receiving the item.Return Shipping to be paid by buyer, unless item defective or damaged.Restocking fee applies unless return due to defective or damaged product. Perishable or Hazardous Goods are not returnable.

Price: 60.43 USD

Location: New York, New York

End Time: 2025-01-07T21:52:44.000Z

Shipping Cost: 0 USD